130w 150w 180w Co2 Laser Cutting Tube 160mm Length High Performance

1, first line the electrode, (+, -) is not wrong. CO2 laser (laser tube) installation instructions:
2, installation of cooling water pipe, the installation method of water from the negative electrode, the positive water and meet the principle of falling out, and the interface can not leak. Sufficient water must be stored in the pre - storage water storage device. After water, the water cooling pipe must be used without air bubbles (must be viewed before each use). If the laser tube is vertically installed, please notice that there is no bubble at the top of the laser tube. When the bubble exists, it will cause damage to the laser tube if it runs.
3, in order to maintain the good performance of the laser tube, please use a temperature controlled water cooler between 20-25 degrees Celsius. If the cooling water is unstable, the output power of the laser tube will be unstable.
4, when the laser tube is installed, there is enough space between the high pressure end of the laser tube and any other metal surface. If the gap is too small, triggering the high pressure of the laser tube will cause fire to the metal surface, which will cause damage to the laser tube and even cause damage to other main components of the laser.
5, it is suggested that an automatic inspection device be added to the cooling water circulation system of the laser tube, so as to prevent the laser tube from overheating due to the water failure. For details, consult the supplier of the laser machine.